Liquid Frisket

Handling

    • Shake well before use.
    • Liquid frisket, colourless / liquid frisket, coloured is ready to use and can apply using a cotton bud, achopstick, nib or a quill. (Don´t use expensive brushes!)
    • The product is dilutable with water, but dries very quickly into a rubbery-type transparent film that does not dissolve in water. (With water diluted product may be penetrate deeper into the ground andit is possible that product will be worse removed!)
    • Please clean tools as soon as possible with water or water and soap.
    • Close the top tightly as soon as possible after use.
    • After the masking fluid is completely dry, the masked picture areas can be painted over using watercolours,gouache colours or AERO COLOR® Professional. (The drying process takes between a fewminutes and more than an hour depending on the thickness of the coat!)
    • After this coat of paint has dried properly too, the dried rubbery-type film of the masking fluid can beremoved by careful rubbing with a dry and non-greasy finger (please do not pull off!).
    • The masking film should not be left on the support for longer than two days and must be completelyremoved; otherwise there is a risk of yellowing of the support!
    • Very soft, weakly grounded textured paper types like e.g. rag paper or torchon paper are not suitablefor masking techniques.
    • Close immediately after use.
    • Store in a cool and dry place.
    • Protect from frost.
    • Individual pre-tests are required.

    Sizes: 20 ml, 100 ml and 250 ml

    Contains:   synthetic resin dispersion without ammonia.

    Signal word:

    Hazard statements
     

    Safety precautions

    Other hazards

    50300  -  Liquid frisket/drawing gum, neutral
    50303  -  Liquid frisket/drawing gum, coloured

    A masking liquid to cover those parts of the design not intended to be part of the picture. For cardboard, paper or other air-brush surfaces. Apply undiluted with cotton buds or small wooden, toothpick-sized stikks, writing or dip-pens.
    The colour design should be applied only after the masking liquid has dried completely. Then rub off the liquid frisket with your finger or an eraser. Do not leave the liquid frisket on the surface for any longer than two days; then remove it completely, as the remaining matter may yellow. Clean your tools thoroughly with soapy water. Close the glass bottle tightly and protect it from frost.